Brahma Female terminal 80340700

This female terminal is designed for terminating high-voltage ignition cables. It has a diameter of 6.35 mm and is compatible with 1/4 inch male spade connectors. Its construction provides high heat resistance and high insulation durability. The terminal is crimped or pushed onto the cable end and slides onto the corresponding spade connector on the ignition transformer or electrode.

Parts of this type are chosen by matching the terminal's inner diameter to the spade width—commonly 1/4 inch, which corresponds to 6.35 mm. The terminal must also fit the cable's gauge and insulation diameter; a size too small will not seat fully, while one too large will not grip the spade reliably. Installation is done by crimping or pushing the terminal onto the stripped cable end and then sliding it onto the male spade connector on the transformer or electrode. Conductive and corrosion-resistant materials such as brass or tinned brass are typical.

Failures occur when the terminal becomes corroded, damaged, or loose. This leads to a poor connection that can cause arcing, voltage drop, or intermittent sparking, resulting in weak or erratic ignition. Inspect the terminal for corrosion, proper seating on the spade, and a secure crimp when ignition problems appear.