Brahma Connection kit 16015967

The connection kit (SKU 16015967) is a factory-matched set of plugs, pins and, in some cases, a short cable segment, used to connect Brahma combustion control automation. It is designed specifically for Brahma TC340P controllers and is compatible with equipment code 16023569. This kit carries low-voltage signals and mains supply between the control board and burner components such as the gas valve, ignition transformer, fan, sensors and actuators. It originates from Italy and is intended for installation, repair and maintenance of burner and boiler control units.

Connector kits of this kind are selected by the exact connector series, pin count, pitch and keying of the mating header on the controller; a kit cannot be assumed to fit other controls even if the pin count appears identical. Before ordering, verify that the terminals match the required size, insulation class and wire length. During installation, fully seat the connector and confirm that each pin locks into the housing before applying power.

Items of this kind can fail through corrosion, bent pins, or loose connections. Poor contact in such a connector may produce almost any electrical fault symptom, including lockout on flame failure, erratic modulation, false air pressure signals, or other intermittent issues. When fault-finding, inspect the wiring harness and its connectors, and check that connectors are fully seated and that pins are clean and properly locked.